Whether professionals or non-professionals in the installation of the regulator, we need to use the correct way to install the regulator, to avoid unnecessary trouble and loss, then how to install the regulator? Below small to teach you the steps to correctly install the regulator.
Regulators properly installed eight steps:
The first step: the regulator input cord to the power distribution board but also the placement of the corresponding fuse, ensure electrical safety, avoid unsafe accidents.
Step two: ensure power wiring must be correct, with particular attention electrical nominal input voltage and output voltage regulator agreed.
The third step: Before starting electrical equipment power supply, the power switch to turn on the regulator, the regulator determines under normal conditions, it can be carried out related work.
Step four: When the regulator is not so long, you need to turn off the power switch, reducing power consumption.
Step Five: In the time necessary to reduce the regulator's load, overload can cause the regulator is not working properly.
Step Six: When using a motor equipment operation, it should use high-capacity regulator, to prevent tripping device is in use, the fuse blows appear.
Step Seven: In order to prevent local and regulator connection will produce high heat, thermal conductivity, better use of copper wire and screw the interface at the bear.
Step Eight: Correct installed a regulator, but also need to master the correct way to use specific reference to "the use of non-contact voltage regulator Notes," a text, a detailed description.
These are the steps for proper installation of the regulator.